Mr. Mark Softer is a decal softener.It can soften surfaces with uneven molds, curved surfaces, hard decals, etc. and make them blend into the surface.You can achieve the effect by applying it over the decal that has been pasted in advance.Be careful not to apply too much as the softening solvent will quickly soften the decal.The decal itself may melt, break when following the surface, or erode the painted surface.This product is water soluble. Adding water as appropriate will dilute the effect of the solvent and prevent rapid softening. Depending on the painted surface to be used and the type of decal, it may be best to dilute it with water before use.After pasting the decal, lightly press down the decal with a lightly moistened Mr. cotton swab, Mr. Clean Stick 2, or a non-dusty rag to ensure that the decal adheres firmly to the surface of the part.At that time, wipe off the excess Mr. Mark Softer to prevent it from becoming too soft. A cotton swab soaked in water can be used to neutralize the mark softener and prevent it from becoming too soft with the solvent.If there are air bubbles between the decal and the part (silvering), after the decal has dried, carefully pierce the decal with a needle or design knife. After that, by applying Mr. Mark Softer again, the decal softens again, air bubbles disappear, and the decal adheres firmly to the surface of the part.One way to prevent silvering is to have a glossy surface finish on the substrate the decal will be applied to.
